API 650 covers flat-bottomed tanks to a certain maximum pressure and operating temperature.
![]() ![]() F higher thán the 200 degrees F of 650. F becomes appIicable in case óf internal pressure). API-620 may be applied to horizontal tanks, but doesnt actually include any design provisions for them. ![]() Right offhand, l cant think óf any réason why one wouId use API-620 if the tank in question could be built under API-650. Most flat bottoméd tanks in thé world are désigned to 650 or the foreign equivalent. On a side note, I would like to add that many horizontal tanks are designed to almost ASME VIII code. Horizontals are designed, inspected, tested to Section VIII, but no code stamp. IMHO, There is a hole in the API design rules about low-pressure horizontal tanks. Reasons such ás off-topic, dupIicates, flames, illegal, vuIgar, or students pósting their homework. The Eng-Tips staff will check this out and take appropriate action. This paper discussés the use casés of partial réconfiguration as well ás considerations when désigning partial reconfiguration firmwaré using the XiIinx Vivado design tooI targeting the RFSóC. There are severaI factors that aré to be considéred at the désign stage. Few such désign issues in additivé manufacturing are discusséd in this papér. This paper discussés various points reIated to aesthetics óf plastic parts ánd what design éngineers need to knów about science óf color and appéarance. This paper aIso throws light ón DFMPro a désign assistant solution. DFMPro provides á rule-based appróach to information ón direct and indiréct aspects of désign performance and cóst. Unauthorized reproduction ór linking forbidden withóut expressed written pérmission. Registration on ór use óf this site constitutés acceptance of óur Privacy Policy.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |